
Vossen HF-7-Style Silver Mesh Forged Wheels
Replica · Silver
Fitting Dacia Duster Extreme wheels? This page gives the 2023 Dacia Duster Extreme bolt pattern (5x114.3), centre bore, factory rim size and the offset range for aftermarket and forged Dacia Duster Extreme rims: the same spec sheet ANKUSI uses when machining forged wheels for this car.
Dacia Duster Extreme (2023): 5x114.3 bolt pattern, 66.1mm center bore. Factory wheels: 17x6.5J F/R. Reference fitment ranges.
✓ Data check: the bolt pattern and center bore on this page match an independent fitment reference. Last reviewed September 18, 2026. How we verify
| Configuration | Wheel Size & Offset |
|---|---|
| Factory (OE) | 17x6.5J F/R |
| Flush Fitment | 18x7.5J at ET40 offset |
| Maximum Aggressive | 19x8.0J at ET35 offset |
Every design below is forged to order, so it can be machined to the Dacia Duster Extreme's 5x114.3 bolt pattern and 66.1 mm center bore, with the width and offset calculated for your setup.

Replica · Silver

Monoblock · Bright Silver / Gloss Black

Monoblock · Hyper Silver

Replica · Matte Silver

Deep Dish · Gloss Black

Deep Dish · Metallic Gray

Monoblock · Gloss Black

Replica · Gloss Black
Use these two references before ordering: the left diagram shows where each spec (PCD, center bore, offset, width and diameter) is measured on the wheel; the right diagram shows how positive, zero and negative offset shift the wheel face relative to the hub centerline.


SUVs carry more curb weight higher off the ground, so wheel strength and rotational mass both matter more than on a comparable sedan — a heavier wheel amplifies body roll and slows steering response exactly where the platform is already working hardest. Forging keeps the wheel light without giving up the load rating the factory suspension geometry was tuned around.
The Dacia Duster Extreme runs a 5x114.3 bolt pattern, 66.1mm center bore, and a 17x6.5J, front and rear, wheel from the factory. Our Flush Fitment reference is 18x7.5J ET40, which tucks the tire under the fender lip on a stock-height Dacia Duster Extreme. Our Maximum Aggressive reference is 19x8.0J ET35 — beyond that offset, expect rubbing against the inner fender liner under compression without further trimming.
The 2023 Dacia Duster Extreme (SUV) uses a 5x114.3 bolt pattern with a 66.1mm center bore. Factory wheels are 17x6.5J F/R.
Why the factory spec works for most owners:
ANKUSI builds these wheels — we are the forging factory, not a reseller. For the Dacia Duster Extreme (2023) we drill the 5x114.3 pattern and cut the centre bore to 66.1mm on our own CNC line, so the wheel hub-centres on the car with no spacer rings, in whatever diameter, width and offset you specify.
Converting these ET figures to backspacing? Use the wheel offset and backspacing calculator.
The figures on this page are part of our open wheel fitment dataset — 10,093 vehicles, free to download, CC BY 4.0.
Backspacing is calculated as wheel width (in) ÷ 2 + offset (mm) ÷ 25.4 + 0.5 (flange allowance):
Want to check a different width or offset before you order? Use our Offset & Backspacing Calculator to solve the numbers yourself, or looking for your exact Dacia spec, or want a wheel built to a custom offset for your Dacia Duster Extreme? Contact ANKUSI with your bolt pattern and offset target and we will confirm the correct forged wheel spec for your build.