
Chrysler OEM-Style Gunmetal / Machined Split Forged Wheels
Monoblock · Gunmetal / Machined
Fitting Chrysler Sebring wheels? This page gives the 2007 Chrysler Sebring bolt pattern (5x114.3), centre bore, factory rim size and the offset range for aftermarket and forged Chrysler Sebring rims: the same spec sheet ANKUSI uses when machining forged wheels for this car.
Chrysler Sebring (2007): 5x114.3 bolt pattern, 67.1mm center bore. Factory wheels: 17x6.5J F/R. Reference fitment ranges.
✓ Data check: the bolt pattern and center bore on this page match an independent fitment reference. Last reviewed September 18, 2026. How we verify
| Configuration | Wheel Size & Offset |
|---|---|
| Factory (OE) | 17x6.5J F/R |
| Flush Fitment | 18x7.5J at ET38 offset |
| Maximum Aggressive | 19x8.0J at ET35 offset |
Every design below is forged to order, so it can be machined to the Chrysler Sebring's 5x114.3 bolt pattern and 67.1 mm center bore, with the width and offset calculated for your setup.

Monoblock · Gunmetal / Machined

Monoblock · Polished

Replica · Gloss Black

Replica · Gloss Black

Replica

Monoblock · Gloss Black


Deep Dish · Gloss Black
Use these two references before ordering: the left diagram shows where each spec (PCD, center bore, offset, width and diameter) is measured on the wheel; the right diagram shows how positive, zero and negative offset shift the wheel face relative to the hub centerline.


The Chrysler Sebring's factory wheel spec reflects a deliberate balance between comfort, steering feel and durability that the engineering team tuned for. Forging lets ANKUSI match that same strength target while trimming rotational mass — the part of a wheel upgrade that actually changes how the car drives, not just how it looks.
The Chrysler Sebring runs a 5x114.3 bolt pattern, 67.1mm center bore, and a 17x6.5J, front and rear, wheel from the factory. Our Flush Fitment reference is 18x7.5J ET38, which tucks the tire under the fender lip on a stock-height Chrysler Sebring. Our Maximum Aggressive reference is 19x8.0J ET35 — beyond that offset, expect rubbing against the inner fender liner under compression without further trimming.
The 2007 Chrysler Sebring (Sedan) uses a 5x114.3 bolt pattern with a 67.1mm center bore. Factory wheels are 17x6.5J F/R.
Why the factory spec works for most owners:
ANKUSI builds these wheels — we are the forging factory, not a reseller. For the Chrysler Sebring (2007) we drill the 5x114.3 pattern and cut the centre bore to 67.1mm on our own CNC line, so the wheel hub-centres on the car with no spacer rings, in whatever diameter, width and offset you specify.
Converting these ET figures to backspacing? Use the wheel offset and backspacing calculator.
The figures on this page are part of our open wheel fitment dataset — 10,093 vehicles, free to download, CC BY 4.0.
Backspacing is calculated as wheel width (in) ÷ 2 + offset (mm) ÷ 25.4 + 0.5 (flange allowance):
Want to check a different width or offset before you order? Use our Offset & Backspacing Calculator to solve the numbers yourself, or looking for your exact Chrysler spec, or want a wheel built to a custom offset for your Chrysler Sebring? Contact ANKUSI with your bolt pattern and offset target and we will confirm the correct forged wheel spec for your build.