
HRE Performance P200-Style Bronze Cross-Spoke Forged Wheels
Replica · Bronze
Fitting ABT VW Passat wheels? This page gives the 2005 ABT VW Passat bolt pattern (5x112), centre bore, factory rim size and the offset range for aftermarket and forged ABT VW Passat rims: the same spec sheet ANKUSI uses when machining forged wheels for this car.
ABT VW Passat (2005): 5x112 bolt pattern, 57.1mm center bore. Factory wheels: 19x8.5J F/R. Reference fitment ranges.
Data check: the bolt pattern and center bore on this page have not yet been confirmed by a second independent source. Measure your hub or ask us before ordering. How we verify
| Configuration | Wheel Size & Offset |
|---|---|
| Factory (OE) | 19x8.5J F/R |
| Flush Fitment | 19x9.0J at ET38 offset |
| Maximum Aggressive | 20x9.0J at ET35 offset |
Every design below is forged to order, so it can be machined to the ABT VW Passat's 5x112 bolt pattern and 57.1 mm center bore, with the width and offset calculated for your setup.

Replica · Bronze

Monoblock · Chrome


Monoblock · Matte Bronze


Monoblock · Gloss Black

Replica · Gloss Black

Monoblock · Metallic Gray
Use these two references before ordering: the left diagram shows where each spec (PCD, center bore, offset, width and diameter) is measured on the wheel; the right diagram shows how positive, zero and negative offset shift the wheel face relative to the hub centerline.


A sedan's wheel spec is a balance point the factory tuned between ride comfort, steering feel, and everyday durability. Forging lets us hold that same structural margin while cutting rotational mass, which is where most of the real-world benefit — quicker steering response, marginally better ride — actually comes from.
The ABT VW Passat runs a 5x112 bolt pattern, 57.1mm center bore, and a 19x8.5J, front and rear, wheel from the factory. Our Flush Fitment reference is 19x9.0J ET38, which tucks the tire under the fender lip on a stock-height ABT VW Passat. Our Maximum Aggressive reference is 20x9.0J ET35 — beyond that offset, expect rubbing against the inner fender liner under compression without further trimming.
The 2005 ABT VW Passat (Sedan) uses a 5x112 bolt pattern with a 57.1mm center bore. Factory wheels are 19x8.5J F/R.
Why the factory spec works for most owners:
ANKUSI builds these wheels — we are the forging factory, not a reseller. For the ABT VW Passat (2005) we drill the 5x112 pattern and cut the centre bore to 57.1mm on our own CNC line, so the wheel hub-centres on the car with no spacer rings, in whatever diameter, width and offset you specify.
Converting these ET figures to backspacing? Use the wheel offset and backspacing calculator.
The figures on this page are part of our open wheel fitment dataset — 10,093 vehicles, free to download, CC BY 4.0.
Backspacing is calculated as wheel width (in) ÷ 2 + offset (mm) ÷ 25.4 + 0.5 (flange allowance):
Want to check a different width or offset before you order? Use our Offset & Backspacing Calculator to solve the numbers yourself, or looking for your exact abt spec, or want a wheel built to a custom offset for your ABT VW Passat? Contact ANKUSI with your bolt pattern and offset target and we will confirm the correct forged wheel spec for your build.