
Black / Machined Petal-Spoke Machined Face Forged Wheels
Monoblock · Black Machined
Fitting ABT Audi RS6 Avant wheels? This page gives the 2003 ABT Audi RS6 Avant bolt pattern (5x112), centre bore, factory rim size and the offset range for aftermarket and forged ABT Audi RS6 Avant rims: the same spec sheet ANKUSI uses when machining forged wheels for this car.
ABT Audi RS6 Avant (2003): 5x112 bolt pattern, 57.1mm center bore. Factory wheels: 19x9.0J F/R. Reference fitment ranges.
✓ Data check: the bolt pattern and center bore on this page match an independent fitment reference. Last reviewed September 18, 2026. How we verify
| Configuration | Wheel Size & Offset |
|---|---|
| Factory (OE) | 19x9.0J F/R |
| Flush Fitment | 20x9.5J at ET25 offset |
| Maximum Aggressive | 20x10.0J at ET20 offset |
Every design below is forged to order, so it can be machined to the ABT Audi RS6 Avant's 5x112 bolt pattern and 57.1 mm center bore, with the width and offset calculated for your setup.

Monoblock · Black Machined

Monoblock · Gloss White

Monoblock · Mirror Polished Silver

Monoblock · Gloss Black

Center-Lock · Gloss White

Monoblock · Black Machined

Replica · Matte Bronze

Replica · Champagne
Use these two references before ordering: the left diagram shows where each spec (PCD, center bore, offset, width and diameter) is measured on the wheel; the right diagram shows how positive, zero and negative offset shift the wheel face relative to the hub centerline.


Wagons split the difference between sedan agility and load-carrying duty, and the wheels have to serve both roles. A forged wheel holds the same structural margin as the factory piece while trimming rotational weight, which benefits both the empty-car handling and the loaded-car ride.
The ABT Audi RS6 Avant runs a 5x112 bolt pattern, 57.1mm center bore, and a 19x9.0J, front and rear, wheel from the factory. Our Flush Fitment reference is 20x9.5J ET25, which tucks the tire under the fender lip on a stock-height ABT Audi RS6 Avant. Our Maximum Aggressive reference is 20x10.0J ET20 — beyond that offset, expect rubbing against the inner fender liner under compression without further trimming.
The 2003 ABT Audi RS6 Avant (Wagon) uses a 5x112 bolt pattern with a 57.1mm center bore. Factory wheels are 19x9.0J F/R.
Why the factory spec works for most owners:
ANKUSI builds these wheels — we are the forging factory, not a reseller. For the ABT Audi RS6 Avant (2003) we drill the 5x112 pattern and cut the centre bore to 57.1mm on our own CNC line, so the wheel hub-centres on the car with no spacer rings, in whatever diameter, width and offset you specify.
Converting these ET figures to backspacing? Use the wheel offset and backspacing calculator.
The figures on this page are part of our open wheel fitment dataset — 10,093 vehicles, free to download, CC BY 4.0.
Backspacing is calculated as wheel width (in) ÷ 2 + offset (mm) ÷ 25.4 + 0.5 (flange allowance):
Want to check a different width or offset before you order? Use our Offset & Backspacing Calculator to solve the numbers yourself, or looking for your exact abt spec, or want a wheel built to a custom offset for your ABT Audi RS6 Avant? Contact ANKUSI with your bolt pattern and offset target and we will confirm the correct forged wheel spec for your build.