
BBS LM-Style Gunmetal Mesh Polished Deep Lip Forged Wheels
Deep Dish · Gunmetal
Fitting Dacia Lodgy wheels? This page gives the 2013 Dacia Lodgy bolt pattern (4x100), centre bore, factory rim size and the offset range for aftermarket and forged Dacia Lodgy rims: the same spec sheet ANKUSI uses when machining forged wheels for this car.
Dacia Lodgy (2013): 4x100 bolt pattern, 60.1mm center bore. Factory wheels: 15x6.0J F/R. Reference fitment ranges.
✓ Data check: the bolt pattern and center bore on this page match an independent fitment reference. Last reviewed September 18, 2026. How we verify
| Configuration | Wheel Size & Offset |
|---|---|
| Factory (OE) | 15x6.0J F/R |
| Flush Fitment | 16x6.5J at ET38 offset |
| Maximum Aggressive | 17x7.0J at ET35 offset |
Every design below is forged to order, so it can be machined to the Dacia Lodgy's 4x100 bolt pattern and 60.1 mm center bore, with the width and offset calculated for your setup.

Deep Dish · Gunmetal

Monoblock · Gloss White


2-Piece · Gold

Monoblock · Gold

Deep Dish · Gunmetal

Monoblock · Bronze Gold

Monoblock · Gloss White
Use these two references before ordering: the left diagram shows where each spec (PCD, center bore, offset, width and diameter) is measured on the wheel; the right diagram shows how positive, zero and negative offset shift the wheel face relative to the hub centerline.


Minivans carry passengers and cargo across a wide range of loaded conditions, so the factory wheel spec is built around a conservative load margin. Forging lets us hold that same margin while trimming rotational mass, which shows up as smoother ride quality whether the vehicle is empty or fully loaded.
The Dacia Lodgy runs a 4x100 bolt pattern, 60.1mm center bore, and a 15x6.0J, front and rear, wheel from the factory. Our Flush Fitment reference is 16x6.5J ET38, which tucks the tire under the fender lip on a stock-height Dacia Lodgy. Our Maximum Aggressive reference is 17x7.0J ET35 — beyond that offset, expect rubbing against the inner fender liner under compression without further trimming.
The 2013 Dacia Lodgy (MPV) uses a 4x100 bolt pattern with a 60.1mm center bore. Factory wheels are 15x6.0J F/R.
Why the factory spec works for most owners:
ANKUSI builds these wheels — we are the forging factory, not a reseller. For the Dacia Lodgy (2013) we drill the 4x100 pattern and cut the centre bore to 60.1mm on our own CNC line, so the wheel hub-centres on the car with no spacer rings, in whatever diameter, width and offset you specify.
Converting these ET figures to backspacing? Use the wheel offset and backspacing calculator.
The figures on this page are part of our open wheel fitment dataset — 10,093 vehicles, free to download, CC BY 4.0.
Backspacing is calculated as wheel width (in) ÷ 2 + offset (mm) ÷ 25.4 + 0.5 (flange allowance):
Want to check a different width or offset before you order? Use our Offset & Backspacing Calculator to solve the numbers yourself, or looking for your exact Dacia spec, or want a wheel built to a custom offset for your Dacia Lodgy? Contact ANKUSI with your bolt pattern and offset target and we will confirm the correct forged wheel spec for your build.