
APEX-Style Chrome 5 Y-Spoke Forged Wheels
Monoblock · Chrome
Fitting Toyota ProAce Verso wheels? This page gives the 2016 Toyota ProAce Verso bolt pattern (5x108), centre bore, factory rim size and the offset range for aftermarket and forged Toyota ProAce Verso rims: the same spec sheet ANKUSI uses when machining forged wheels for this car.
Toyota ProAce Verso (2016): 5x108 bolt pattern, 65.1mm center bore. Factory wheels: F/R: 17x7.0J at ET47 offset, front and rear. Reference fitment ranges.
✓ Data check: the bolt pattern and center bore on this page match an independent fitment reference. Last reviewed September 18, 2026. How we verify
| Configuration | Wheel Size & Offset |
|---|---|
| Factory (OE) | F/R: 17x7.0J F/R |
| Flush Fitment | 18x8.0J at ET38 offset |
| Maximum Aggressive | 19x8.5J at ET35 offset |
Every design below is forged to order, so it can be machined to the Toyota ProAce Verso's 5x108 bolt pattern and 65.1 mm center bore, with the width and offset calculated for your setup.

Monoblock · Chrome

Replica · Black Chrome

Replica · Brushed Silver


Replica · Gold

Replica · Bronze

Replica · Gloss White

Monoblock · Brushed Silver
Use these two references before ordering: the left diagram shows where each spec (PCD, center bore, offset, width and diameter) is measured on the wheel; the right diagram shows how positive, zero and negative offset shift the wheel face relative to the hub centerline.


Minivans carry passengers and cargo across a wide range of loaded conditions, so the factory wheel spec is built around a conservative load margin. Forging lets us hold that same margin while trimming rotational mass, which shows up as smoother ride quality whether the vehicle is empty or fully loaded.
The Toyota ProAce Verso runs a 5x108 bolt pattern, 65.1mm center bore, and a 17x7.0J, front and rear, wheel from the factory. Our Flush Fitment reference is 18x8.0J ET38, which tucks the tire under the fender lip on a stock-height Toyota ProAce Verso. Our Maximum Aggressive reference is 19x8.5J ET35 — beyond that offset, expect rubbing against the inner fender liner under compression without further trimming.
The 2016 Toyota ProAce Verso (MPV) uses a 5x108 bolt pattern with a 65.1mm center bore. Factory wheels are F/R: 17x7.0J F/R.
Why the factory spec works for most owners:
ANKUSI builds these wheels — we are the forging factory, not a reseller. For the Toyota ProAce Verso (2016) we drill the 5x108 pattern and cut the centre bore to 65.1mm on our own CNC line, so the wheel hub-centres on the car with no spacer rings, in whatever diameter, width and offset you specify.
Converting these ET figures to backspacing? Use the wheel offset and backspacing calculator.
The figures on this page are part of our open wheel fitment dataset — 10,093 vehicles, free to download, CC BY 4.0.
Backspacing is calculated as wheel width (in) ÷ 2 + offset (mm) ÷ 25.4 + 0.5 (flange allowance):
Final clearance depends on the exact tire model, suspension height, brake package, alignment and vehicle tolerances. A physical test fit is recommended before production.
Want to check a different width or offset before you order? Use our Offset & Backspacing Calculator to solve the numbers yourself, or looking for your exact Toyota spec, or want a wheel built to a custom offset for your Toyota ProAce Verso? Contact ANKUSI with your bolt pattern and offset target and we will confirm the correct forged wheel spec for your build.