
Datsun OEM-Style Gold Cross-Spoke Mesh 2-Piece Polished Lip Forged Wheels
2-Piece · Gold / Polished Lip
Fitting Datsun on-DO wheels? This page gives the 2015 Datsun on-DO bolt pattern (4x98), centre bore, factory rim size and the offset range for aftermarket and forged Datsun on-DO rims: the same spec sheet ANKUSI uses when machining forged wheels for this car.
Datsun on-DO (2015): 4x98 bolt pattern, 58.6mm center bore. Factory wheels: 14x5.5J F/R. Reference fitment ranges.
✓ Data check: the bolt pattern and center bore on this page match an independent fitment reference. Last reviewed September 18, 2026. How we verify
| Configuration | Wheel Size & Offset |
|---|---|
| Factory (OE) | 14x5.5J F/R |
| Flush Fitment | 15x6.5J at ET30 offset |
| Maximum Aggressive | 16x7.0J at ET28 offset |
Every design below is forged to order, so it can be machined to the Datsun on-DO's 4x98 bolt pattern and 58.6 mm center bore, with the width and offset calculated for your setup.

2-Piece · Gold / Polished Lip

Deep Dish · Gunmetal

Monoblock · Matte Silver

Monoblock · Black Machined

Monoblock · Bright Silver


Monoblock · Gloss White

Deep Dish · Gunmetal
Use these two references before ordering: the left diagram shows where each spec (PCD, center bore, offset, width and diameter) is measured on the wheel; the right diagram shows how positive, zero and negative offset shift the wheel face relative to the hub centerline.


A sedan's wheel spec is a balance point the factory tuned between ride comfort, steering feel, and everyday durability. Forging lets us hold that same structural margin while cutting rotational mass, which is where most of the real-world benefit — quicker steering response, marginally better ride — actually comes from.
The Datsun on-DO runs a 4x98 bolt pattern, 58.6mm center bore, and a 14x5.5J, front and rear, wheel from the factory. Our Flush Fitment reference is 15x6.5J ET30, which tucks the tire under the fender lip on a stock-height Datsun on-DO. Our Maximum Aggressive reference is 16x7.0J ET28 — beyond that offset, expect rubbing against the inner fender liner under compression without further trimming.
The 2015 Datsun on-DO (Sedan) uses a 4x98 bolt pattern with a 58.6mm center bore. Factory wheels are 14x5.5J F/R.
Why the factory spec works for most owners:
ANKUSI builds these wheels — we are the forging factory, not a reseller. For the Datsun on-DO (2015) we drill the 4x98 pattern and cut the centre bore to 58.6mm on our own CNC line, so the wheel hub-centres on the car with no spacer rings, in whatever diameter, width and offset you specify.
Converting these ET figures to backspacing? Use the wheel offset and backspacing calculator.
The figures on this page are part of our open wheel fitment dataset — 10,093 vehicles, free to download, CC BY 4.0.
Backspacing is calculated as wheel width (in) ÷ 2 + offset (mm) ÷ 25.4 + 0.5 (flange allowance):
Want to check a different width or offset before you order? Use our Offset & Backspacing Calculator to solve the numbers yourself, or looking for your exact Datsun spec, or want a wheel built to a custom offset for your Datsun on-DO? Contact ANKUSI with your bolt pattern and offset target and we will confirm the correct forged wheel spec for your build.