
BBS-Style Gold Mesh Polished Lip 2-Piece Forged Wheels
2-Piece · Gold
Fitting Dacia Sandero Stepway wheels? This page gives the 2013 Dacia Sandero Stepway bolt pattern (4x100), centre bore, factory rim size and the offset range for aftermarket and forged Dacia Sandero Stepway rims: the same spec sheet ANKUSI uses when machining forged wheels for this car.
Dacia Sandero Stepway (2013): 4x100 bolt pattern, 60.1mm center bore. Factory wheels: 16x6.0J F/R. Reference fitment ranges.
✓ Data check: the bolt pattern and center bore on this page match an independent fitment reference. Last reviewed September 18, 2026. How we verify
| Configuration | Wheel Size & Offset |
|---|---|
| Factory (OE) | 16x6.0J F/R |
| Flush Fitment | 17x7.0J at ET35 offset |
| Maximum Aggressive | 17x7.5J at ET32 offset |
Every design below is forged to order, so it can be machined to the Dacia Sandero Stepway's 4x100 bolt pattern and 60.1 mm center bore, with the width and offset calculated for your setup.

2-Piece · Gold

Monoblock · Gold

Monoblock · Gloss White

Deep Dish · Gunmetal


Monoblock · Bright Silver

Monoblock · Silver

Monoblock · Black Machined
Use these two references before ordering: the left diagram shows where each spec (PCD, center bore, offset, width and diameter) is measured on the wheel; the right diagram shows how positive, zero and negative offset shift the wheel face relative to the hub centerline.


SUVs carry more curb weight higher off the ground, so wheel strength and rotational mass both matter more than on a comparable sedan — a heavier wheel amplifies body roll and slows steering response exactly where the platform is already working hardest. Forging keeps the wheel light without giving up the load rating the factory suspension geometry was tuned around.
The Dacia Sandero Stepway runs a 4x100 bolt pattern, 60.1mm center bore, and a 16x6.0J, front and rear, wheel from the factory. Our Flush Fitment reference is 17x7.0J ET35, which tucks the tire under the fender lip on a stock-height Dacia Sandero Stepway. Our Maximum Aggressive reference is 17x7.5J ET32 — beyond that offset, expect rubbing against the inner fender liner under compression without further trimming.
The 2013 Dacia Sandero Stepway (Crossover) uses a 4x100 bolt pattern with a 60.1mm center bore. Factory wheels are 16x6.0J F/R.
Why the factory spec works for most owners:
ANKUSI builds these wheels — we are the forging factory, not a reseller. For the Dacia Sandero Stepway (2013) we drill the 4x100 pattern and cut the centre bore to 60.1mm on our own CNC line, so the wheel hub-centres on the car with no spacer rings, in whatever diameter, width and offset you specify.
Converting these ET figures to backspacing? Use the wheel offset and backspacing calculator.
The figures on this page are part of our open wheel fitment dataset — 10,093 vehicles, free to download, CC BY 4.0.
Backspacing is calculated as wheel width (in) ÷ 2 + offset (mm) ÷ 25.4 + 0.5 (flange allowance):
Want to check a different width or offset before you order? Use our Offset & Backspacing Calculator to solve the numbers yourself, or looking for your exact Dacia spec, or want a wheel built to a custom offset for your Dacia Sandero Stepway? Contact ANKUSI with your bolt pattern and offset target and we will confirm the correct forged wheel spec for your build.