
Transparent Copper Petal Forged Wheels
Monoblock · Transparent Copper
Fitting Breckland Beira wheels? This page gives the 2009 Breckland Beira bolt pattern (5x110), centre bore, factory rim size and the offset range for aftermarket and forged Breckland Beira rims: the same spec sheet ANKUSI uses when machining forged wheels for this car.
Breckland Beira (2009): 5x110 bolt pattern, 65.1mm center bore. Factory wheels: 19x8.5J F/R. Reference fitment ranges.
Data check: the bolt pattern and center bore on this page have not yet been confirmed by a second independent source. Measure your hub or ask us before ordering. How we verify
| Configuration | Wheel Size & Offset |
|---|---|
| Factory (OE) | 19x8.5J F/R |
| Flush Fitment | 19x9.0J at ET40 offset |
| Maximum Aggressive | 19x9.5J at ET35 offset |
Every design below is forged to order, so it can be machined to the Breckland Beira's 5x110 bolt pattern and 65.1 mm center bore, with the width and offset calculated for your setup.

Monoblock · Transparent Copper

Monoblock · Silver

Monoblock · Pink

2-Piece · Custom Finish


Monoblock · Custom Finish

Monoblock · Bright Silver

Monoblock · Gloss Black
Use these two references before ordering: the left diagram shows where each spec (PCD, center bore, offset, width and diameter) is measured on the wheel; the right diagram shows how positive, zero and negative offset shift the wheel face relative to the hub centerline.


Convertibles lose some of the structural rigidity a fixed roof provides, which means the suspension and wheels end up doing more of the work to keep the chassis composed. A forged wheel keeps unsprung mass down without sacrificing the strength margin the factory built in — useful on a platform that's already managing extra flex.
The Breckland Beira runs a 5x110 bolt pattern, 65.1mm center bore, and a 19x8.5J, front and rear, wheel from the factory. Our Flush Fitment reference is 19x9.0J ET40, which tucks the tire under the fender lip on a stock-height Breckland Beira. Our Maximum Aggressive reference is 19x9.5J ET35 — beyond that offset, expect rubbing against the inner fender liner under compression without further trimming.
The 2009 Breckland Beira (Roadster) uses a 5x110 bolt pattern with a 65.1mm center bore. Factory wheels are 19x8.5J F/R.
Why the factory spec works for most owners:
ANKUSI builds these wheels — we are the forging factory, not a reseller. For the Breckland Beira (2009) we drill the 5x110 pattern and cut the centre bore to 65.1mm on our own CNC line, so the wheel hub-centres on the car with no spacer rings, in whatever diameter, width and offset you specify.
Converting these ET figures to backspacing? Use the wheel offset and backspacing calculator.
The figures on this page are part of our open wheel fitment dataset — 10,093 vehicles, free to download, CC BY 4.0.
Backspacing is calculated as wheel width (in) ÷ 2 + offset (mm) ÷ 25.4 + 0.5 (flange allowance):
Want to check a different width or offset before you order? Use our Offset & Backspacing Calculator to solve the numbers yourself, or looking for your exact Breckland spec, or want a wheel built to a custom offset for your Breckland Beira? Contact ANKUSI with your bolt pattern and offset target and we will confirm the correct forged wheel spec for your build.