Exeed Wheel Fitment Guide
25 fitment guides for Exeed, covering 2019 to 2025, built around the 5x108 bolt pattern. Browse the full list below, then open a model for bolt pattern, center bore, OE offset, flush and max wheel sizes, and offset/backspacing conversions.
Exeed Bolt Pattern & Center Bore Notes
Based on the 25 Exeed fitment guides we cover, we have documented 2 distinct bolt pattern / center bore combinations across different Exeed platforms and model years:
- 5x108 bolt pattern, 65.1mm center bore — 18 models we cover, spanning 2019–2025.
- 5x108 bolt pattern, 60.1mm center bore — 7 models we cover, spanning 2019–2025.
Do not mix platforms: a wheel forged for one Exeed bolt pattern / center bore combination will not hub-center correctly on a different one, even if the diameter looks right. Always confirm your exact model and year against the bolt pattern and center bore listed on that model page below before ordering — or send us your VIN or trim level and we will confirm it for you.
Offset and backspacing recommendations vary by trim even within the same bolt pattern, mainly due to differences in brake caliper size and suspension geometry between base and performance trims. Every ANKUSI wheel is forged to your exact target offset, so send us your Exeed model, year, and trim and we will confirm the correct spec before production — no guessing required.
How to check the bolt pattern on your Exeed
The most common Exeed fitment in our guide is 5x108 with a 65.1 mm center bore (18 of 25 model years we cover).
- Read the stamping on the back of an original wheel: size, offset (ET) and bolt pattern are usually cast into a spoke or the hub pad.
- No stamping? Measure center-to-center between two adjacent lug holes. For 5x108 that distance is 63.5 mm (PCD × sin(180° / 5)). A 2 mm difference already means a different bolt pattern.
- Match generation and year on the model pages below — the same nameplate can change bolt pattern or center bore between generations.
Changing width or offset? Check how far the wheel moves in or out with our offset & backspacing calculator.