
Bronze Gold Cross-Spoke Forged Wheels
Monoblock · Bronze Gold
Fitting Geely Vision FC3 Facelift wheels? This page gives the 2021 Geely Vision FC3 Facelift bolt pattern (4x100), centre bore, factory rim size and the offset range for aftermarket and forged Geely Vision FC3 Facelift rims: the same spec sheet ANKUSI uses when machining forged wheels for this car.
Geely Vision FC3 Facelift (2021): 4x100 bolt pattern, 60.1mm center bore. Factory wheels: 15x6J F/R. Flush and max fitment confirmed on request.
✓ Data check: the bolt pattern and center bore on this page match an independent fitment reference. Last reviewed September 19, 2026. How we verify
Every design below is forged to order, so it can be machined to the Geely Vision FC3 Facelift's 4x100 bolt pattern and 60.1 mm center bore, with the width and offset calculated for your setup.

Monoblock · Bronze Gold

Monoblock · Gloss White

Deep Dish · Gunmetal

Monoblock · Black Machined

Monoblock · Matte Bronze

Monoblock · Silver

Monoblock · Bright Silver

Use these two references before ordering: the left diagram shows where each spec (PCD, center bore, offset, width and diameter) is measured on the wheel; the right diagram shows how positive, zero and negative offset shift the wheel face relative to the hub centerline.


A big saloon lives or dies on ride quality, and the wheel is the first thing that ruins it. Going wider and lower without watching load rating and offset trades away exactly the composure you paid for. Forging lets you add diameter and width while keeping rotating mass close to the factory figure.
We publish the factory specification for the Geely Vision FC3 Facelift below. We have not yet been able to verify aftermarket flush or maximum-aggressive offsets for this exact variant against a source we trust, so we are not listing any - an invented offset is worse than no offset when a wheel has to clear a caliper.
Verification resolved (19 Sep 2026): the 60.1 mm centre bore was briefly withheld after an automated lookup matched the wrong Geely model (Vision X3, 54.1 mm). avtoreference.com lists 60.1 mm for every FC2/FC3 model year (2014-2022) and 54.1 mm only for the FC1 generation, so 60.1 mm has been reinstated.
The 2021 Geely Vision FC3 Facelift (Performance Sedan) uses a 4x100 bolt pattern with a 60.1mm center bore. Factory wheels are 15x6J F/R.
Why the factory spec works for most owners:
ANKUSI builds these wheels — we are the forging factory, not a reseller. For the Geely Vision FC3 Facelift (2021) we drill the 4x100 pattern and cut the centre bore to 60.1mm on our own CNC line, so the wheel hub-centres on the car with no spacer rings, in whatever diameter, width and offset you specify.
Converting these ET figures to backspacing? Use the wheel offset and backspacing calculator.
The figures on this page are part of our open wheel fitment dataset — 10,093 vehicles, free to download, CC BY 4.0.
Published aftermarket fitment for this exact variant is still thin, so we have not committed to a flush or maximum-aggressive figure. Our engineering team is still collecting verified data for this variant. In the meantime the factory specification above is accurate and is the safe reference point for ordering.
Need a wheel for this car now? Contact ANKUSI with your target diameter, width and offset and our engineers will confirm the correct forged spec against your brake package before anything is cut. You can also use our Offset & Backspacing Calculator to work through the numbers yourself.